This kit has it all. The ADK IO Kit(AIK) is a bag of goodies to get the very beginners to start with Android connected electronics. It includes all the bits you need to build several basic circuits, no soldering required!
On top of that, we will open full Android application source code to get you started. The AIK comes with everything pictured and step-by-step 'starter' guide on our Wiki page. The guide will take a complete novice and get them:
- Blinking LEDs - Controlling a servo motor - Reading illuminance of Digital data with Ambient light sensor IC - Responding to buttons - Twisting a volume knob to read an angle position of potential meter (trimpot)
We believe these to be the building blocks of any electronics project based on Android devices. Once these concepts are mastered, very impressive projects are possible using simple recombinations.
Note! : Because breadboard needs many connecting wires(hook-up jumper wire), developer must have a tool which can cut and strip the standard 0.6mm(22AWG) wire.
When you buy it, check if it sets 0.25~0.8mm or 20~30AWG.
ADK I/O Kit Includes:
A. 1 x ADK I/O Kit PCB (2 x 10pin connectors and Digital ambient Light sensor [ ROHM BH1780GLI ] pre-assembled-SMT) B. 1 x Mini Breadboard with strong self-adhesive backing (Random color) C. 1 x Micro Servo ( 9 gram, 1.6kg Torque, 23.6 * 11.4 * 24 mm, 3.0~6.0Volt ) D. 1 x Ribbon Cable is a 10 conductor cable with two 5x2 receptacles with .100” spacing. (100mm length) E. 1 x 3mm Dual color LED ( Red + Green / Cathode common ) F. 1 x 10K potentiometer with a small knob G. 10 x 330Ohm Resistor (1/4Watt, 1%) H. 10 x 10kOhm Resistor (1/4Watt, 1%) I. 2 x Mini Push Button Switch J. 1 x Hook-up wire for breadboard (1 meter, 0.6mm Wire diameter, AWG 22)
