Connector Pack for ODROID-C0
This is a perfect connector pack for various DIY projects with the ODROID-C0.
You need a soldering skill to use this pack.
Most of connectors are identical to the ODROID-C1+.
There are two different USB host connectors in this package.
If you want to make a lower profile board, use a single layer connector.
If you want to make a full connectivity, use a dual layer connector.
A. Double Layer USB Type-A 8-Pin DIP Jack Connector
B. Single Layer USB Type-A 4-Pin DIP Jack Connector
C. IR(InfraRed) Receiver Sensor
This is a remote control receiver module that can accept standard 37.9Khz carrier frequency based wireless data.
D. UART Console Connector
Molex 5268-04a(2.5mm pitch) is mounted on the PCB.
Its mate is Molex 50-37-5043 Wire-to-Board Crimp Housing.
E. 7-pin Strip Male Header
Add pins to the audio I2S interface holes in the ODROID-C0.
F. 20×2-pin Strip Male Header
Add pins to the 40pin GPIO port.